Angel 20K MINI Commercial Juicer
This item is made to order. 1-3 months delivery. Please contact us for info.
Angel 20K MINI - High Volume Quality Juicing Made Easy
The Angel 20K MINI is suitable for juice bars, restaurants, hospitals, clinics that treat their patients with juice and natural therapies, small farms, hotels, retreat centres, and many other types of commercial settings where high-volume juicing is required.
With its high-grade stainless steel crushing gears rotating at only 85 RPM, and a three step extraction process, there is hardly a commercial juicer that can match or come close to the superior yield, nutritional quality and natural taste of the juice from the Angel 20K commercial juicer.
The Angel juicer 20K MINI can process some 50 pounds of veggies/fruits/hour, and be used continuously unlike Angel juicers for home use that may need to be stopped and the filter cleaned once a container or two are full.
Angel 20K Instructions for use:
Before operating the machine Do not operate the machine with wet hands Do not use the machine at in a place with excessive moisture Unplug the Juice extractor from the electrical outlet when not in use, assembling, disassembling, cleaning, and removing food or other contents from the juicer (feeding chute) Avoid contact with moving parts while the machine is in operation Carefully read the instruction manual before operating
Operating Instruction Plug the power cord into a grounded electrical outlet Push the power switch up to run the motor (do not let the twin gears idle more than 15 seconds) If the motor stops from a feed jam/overloading, push the power switch down (reverse position) for 3 to 5 seconds. Place the power switch at the middle to stop the motor
How to disassemble & Clean the machine Let the machine run for about one minute to get rid of excess feed/juice Push the power switch down
Unplug the Juice extractor from the electrical outlet before disassembling and cleaning Remove the housing cover Unscrew the butterfly nuts on both sides and release the latches Remove the screen housing (in case the screen housing does not release easily, turn the power switch ON/OFF one or twice then it will be released smoothly) Remove the twin gears Clean the screen housing with the cleaning brush under running water (do the same with the twin gears) Dry with clean towel and then air dry the parts
How to Assemble the Gears First, Insert the Driving Gear through the Driving Gear Shaft. Please Note! Slowly slide the driving gear through the driving gear shaft, but do not push the gear fully into the slot at this time. Right before the gear is set into the end of the slot, wiggle and/or turn the gear and so it is securely aligned with the gear shaft. Then, push the gear fully into the slot. Make sure the gears are fully seated. Second, Insert the Free Wheel Gear through the Sub-Shaft. Always make sure the gears are fully seated before operating. If you forcefully push the gear all the way into the slot without properly aligning them, the gear shaft can get damaged.
Slowly slide the screen housing over the twin gears and push it back.
Firmly tighten (do not over tighten) the butterfly nuts and place the screen housing cover.
Angel 20K Specifications:
Extracting Method : Twin Gear 3-Step Pressure Extraction
RPM : 85 rpm
Motor : Electric Motor, 1/2 HP
Gear Crushing Power: 10HP
Weight & Dimension : 88 Lbs, 31.5" L x 11" W x 19" H
Capacity : 50 Lbs Vegetables/Fruits per hour (approximate)
For Juice Bar, Restaurant, Hotel and other commercial use